Just A Scrappin’ DT – 3D Projects

Hey everybody! Thanks for stopping by. While the Just A Scrappin’ DT is on a break, there were some members, including myself that volunteered to do a project this week.

The only requirement was for it to be a 3D project.

Supplies
Happy Hauntings Cricut Cartridge
Gypsy by Cricut
Stampin’ Up Cardstock: Basic Grey, Basic Black, Concord Crush
Sentiment: My Pink Stamper – Spookalicious; Memento Tuxedo Black Ink
Other: Purple Ribbon – Michael’s; Red Stickles – Ranger
Adhesive: 3L Foam Squares; Scotch ATG; Red Sticky Tape – Various Sizes

I used three different cuts from the Happy Hauntings Cricut Cartridge.

(3DGrave) 11.70w X 10.21h (PG 101)
(Grave1) 3.68w X 5.15h (PG 60)
(Bat2) 3.51w X 1.00h (PG 53)
(Layer1) 3.52w X 1.00h (PG 53)

As usual I deleted all lines on all of the cuts. On the (Grave1) cut I simply trimmed the grass and the crow to layer on the (3DGrave) cut.

I did not use the (Bat2-s) cut since I used stickles for the red eyes.

Also, make sure you stamp your sentiment and tie your ribbon BEFORE you assemble your box — it could get rather tricky if you don’t!

Thanks for stopping by! Head on over to Just A Scrappin’ to check out what some of my Design Team sisters have done.

Also, make sure to stop by on Saturday as some members of the Just A Scrappin’ DT will be doing a special blog hop.

See you then 🙂